The ideal EPDM
THERMAL INSULATION
for HVAC & R
Aeroflex Tube Insulation Standard Product
available from 6mm ID upto 273mm ID with thickness from 6mm upto 100mm. Other sizes are also available upon request. Aeroflex Closed Cell Tube Insulation, made of EPDM (Ethylene Propylene Diene Monomer Synthetic Rubber) as its main raw material, is easily installed to pipe or tubing. The factory-applied coating of talcum powder on the thick and smooth inner skin helps facilitate and speed up preassembly line. When applied to existing lines, tubing should be slit lengthwise and snapped into place. Slitting can be done on the job easily with razors, blades, knives or shears. Cut edges and joints can be sealed with Aeroseal Adhesive.
Aeroflex Standard and Roll Sheet
Aeroflex standard sheet is available in 0.5m x 2.0m (MS1) and 1.0m x 2.0m (MS2) with the wall thickness from 3 mm up to 50 mm. It prevents heat loss and condensation on large pipeline, tanks, chillers, air ducts and other irregular shaped vessels.
Aeroflex sheet insulations are also available in continuous Roll form. Aeroflex continuous sheet rolls are available from 3mm to 50mm thickness, with the width of 1,000mm, 1,220mm, 1,400mm or above also available upon request. All insulation sheets are made from the same materials as Aeroflex tubing.
Non-Polar Material
Water Absorption & Moisture Permeability
Temperature Range
Flame & Smoke Proof
Non Corrosive
Accessories
Save Energy
AEROFLEX closed cell tube and sheet thermal insulation is a flexible and lightweight EPDM based elastomeric material designed for insulating liquid cooling and heating pipelines. The closed cell structure of Aeroflex provides many advantages over most rigid insulations such as:
- Moisture and vapor resistance without using additional vapor barriers.
- Stable thermal conductivity (K. value / value) throughout service life, due to its dense surface skin and closed cell characteristics.
- Flexibility which makes installation work easy and neat. Outstanding ultraviolet and weather resistance.
AEROFLEX is an ideal thermal insulation for frost control on sub-zero piping. It prevents heat gain and condensation problems on chilled water and refrigerant pipelines, and it also prevents heat loss from hot water plumbing, liquid and dual temperature piping.
FIBERGLASS
(open-cell structure insulation)
Fiberglass thermal insulation is made from compacted small glass fibers. Air occupies the spaces between the fibers which allow atmospheric moisture to penetrate into the insulation, resulting in very high water vapor permeability.
POLYURETHANE FOAM
(semi-opened cell structure insulation)
PU Foam is made of polyols and polyisocyanates mixed with HCFCs or similar gases. The cell wall is very thin and brittle, making it semi-opened cell easily. This allows much moisture penetration, which resulting in high water vapor permeability.
AEROFLEX
(closed cell structure insulation)
Aeroflex thermal insulation is made from synthetic elastomers based material. The elastomeric material makes Aeroflex flexible with closed cell structure (mainly nitrogen gas inside), resulting in very low water vapor permeability.